Pricing Guide

Reliable Roofing & Contractor Services

Your guide to roofing labor pricing, add-on charges, and estimate preparation.


Roofing Labor Pricing Guide

This pricing guide is provided to help customers better understand common roofing labor costs. Prices listed below are for labor unless otherwise noted.

For the most accurate estimate, please message us with photos of the project or schedule an in-person inspection.


Shingle Roofing Labor

Service Unit Labor Price (USD)
Remove 1 Layer of Shingles Per Square 40.00
Remove 2+ Layers of Shingles Per Square 60.00
Install Shingles — Install Only Per Square 60.00
Tear Off + Install — Complete Per Square 100.00
Synthetic Underlayment Per Square 15.00
Ice and Water Shield — Eaves and Valleys Per Square 15.00
Felt Underlayment Per Square 10.00
Ridge Cap Installation Per Linear Foot 3.50
Starter Strip Installation Per Linear Foot 2.00
Drip Edge Installation Per Linear Foot 2.50
Step Flashing Installation Per Linear Foot 8.00
Valley Installation — Open, Metal, or Woven Per Linear Foot 8.00
Pipe Boot Installation Each 35.00
Roof Vent Installation Each 35.00
Skylight Installation Each 150.00
Chimney Flashing Installation Each 150.00

Flat Roofing Labor — EPDM / TPO

Service Unit Labor Price (USD)
Tear Off + Install EPDM or TPO Per Square 120.00
Install EPDM or TPO — Install Only Per Square 80.00
Insulation Board Installation Per Square 20.00

Decking / Sheathing

Service Unit Labor Price (USD)
Replace OSB / Plywood Decking Per Sheet — 4'x8' 75.00
Replace OSB / Plywood Decking Per Square 75.00

Additional Charges

Service Unit Additional Charge (USD)
Steep Pitch — 8/12 to 12/12 Per Square 15.00
Very Steep Pitch — 12/12+ Per Square 25.00
Two or More Stories Per Square 15.00
Additional Tear-Off Layers Per Additional Layer / Per Square 20.00

Important Pricing Notes

  • Prices shown are labor pricing only unless otherwise stated.
  • Material costs are not included unless specifically listed.
  • Final pricing may vary depending on roof pitch, height, accessibility, number of layers, decking condition, and job complexity.
  • Additional repairs may be recommended after tear-off if damaged decking, flashing, ventilation, or structural issues are found.
  • This guide is meant to provide general pricing information and does not replace a formal written estimate.

Need an Estimate?

To get the most accurate price, please message us with:

  • Photos of the roof
  • Approximate roof size, if known
  • Number of stories
  • Any known leaks or damaged areas
  • Whether the job is a repair, tear-off, or full replacement

We will review the information and provide guidance on the next step.

Task Runner